Influence of high velocity oxy-fuel parameters on properties of nanostructured TiO2coatings
MARYAMOSSADAT BOZORGTABAR,MEHDI SALEHI,MOHAMMADREZA RAHIMIPOUR
Bulletin of Materials Science
abstract:A liquid fuel high velocity oxy-fuel (HVOF) thermal spray process has been used to deposit TiO2 nanostructured coatings utilizing a commercially available nanopowder as the feedstock. The coatings were characterized by means of X-ray diffraction analysis (XRD), scanning electron microscopy (SEM) and transmission electron microscope (TEM), respectively. Photocatalytic activity was evaluated as a rate constant of decomposition reaction of methylene blue (MB) determined from the changes of relative concentration of MB with UV irradiation time. The results indicate that the sprayed TiO2coatings were composed of both TiO2phases viz. anatase and rutile, with different phase contents and crystallite sizes. A high anatase content of 80% by volume was achieved at 0·00015, fuel-to-oxygen ratio with nanostructure coating by grain size smaller than feedstock powder. Photocatalytic activity evaluation results indicated that all the TiO2coatings are effective to degradation MB under UV radiation and their activities differ in different spray conditions. It is found that fuel flow rate strongly influenced on phase transformation of anatase to rutile and by optimizing the rate which can promote structural transformation and grain coarsening in coating and improving photocatalytic activity.
keywords:HVOF; TiO2; phase transformation; nanostructure coating
本站文章未经允许不得转载；如欲转载请注明出处，北京桑尧科技开发有限公司网址：http://www.sunspraying.com/
|
