中文版 English
Position:首页 > Technical articles > Theoretical research

Cr3C2–NiCr and WC–Ni thermal spray coatings as alternatives to hard chromium for erosion–corrosion resistance

Time:2012-11-19 08:09:49  From:J. Berget, J.M. Guilemany, A.V. Benedetti  Author:J. Berget, J.M. Guilemany, A.V

Cr3C2–NiCr and WC–Ni thermal spray coatings as alternatives to hard chromium for erosion–corrosion resistance

J. Berget, J.M. Guilemany, A.V. Benedetti
SURFACE & COATINGS TECHNOLOGY

Abstract
Cr3C2 NiCr and WC Ni coatings are widely used for wear applications at high and room temperature, respectively. Due to the high corrosion resistance of NiCr binder, Cr3C2 NiCr coatings are also used in corrosive environments. The application of WC Ni coatings in corrosive media is not recommended due to the poor corrosion resistance of the (pure Ni) metallic matrix. It is well known that the addition of Cr to the metallic binder improves the corrosion properties. Erosion corrosion performance of...More thermal spray coatings is widely influenced by ceramic phase composition, the size of ceramic particles and also the composition of the metallic binder. In the present work, two types of HVOF thermal spray coatings (Cr3C2 NiCr and WC Ni) obtained with different spray conditions were studied and compared with conventional micro-cracked hard chromium coatings. Both as-sprayed and polished samples were tested under two erosion corrosion conditions with different erosivity. Tungsten carbide coatings showed better performance under the most erosive condition, while chromium carbide coatings were superior under less erosive conditions. Some of the tungsten carbide coatings and hard chromium showed similar erosion corrosion behaviour under more and less erosive conditions. The erosion corrosion and electrochemical results showed that surface polishing improved the erosion corrosion properties of the thermally sprayed coatings. The corrosion behaviour of the different coatings has been compared using Electrochemical Impedance Spectroscopy (EIS) and polarization curves. Total material loss due to erosion corrosion was determined by weight loss measurements. An estimation of the corrosion contribution to the total weight loss was also given.

keywords:Erosion–corrosion; Cr3C2–NiCr; HVOF; Thermal spray; Hard chromium; WC–Ni

本站文章未经允许不得转载;如欲转载请注明出处,北京桑尧科技开发有限公司网址:http://www.sunspraying.com/

Support
返回首页
Home page
发表评论 共有条评论
用户名: 密码:
验证码: 匿名发表
Information
Article
    无相关信息
Update
Hot